Qualitel QT6131, Инструкция по эксплуатации

Страница: 13 / 14

13
PAUSE FUNCTION
When dialing, press the REDIAL/P button to insert a 3.6s pause time between digits. This function is used
behind a PABX. Insert the PAUSE between the PABX access digit (usually 0 or 9) and the number to be
dialed. Use this function when you want to redial a number or when you store a number in memory.
LOW BATTERY DETECTION
When the combined battery voltage is lower than 3.9V, the LCD displays the
“ “icon as a reminder to
replace the batteries.
NOTE: The phone will function without batteries except for the backlight display. Insert 3x1.5V AA Alcaline
Batteries.
MUTE FUNCTION
Press the MUTE key to mute the microphone. The other party will not be able to hear your conversation.
Press the MUTE key again to restore two-way conversation.
RINGING VOLUME CONTROL
Slide the RING (Hi/Mid/Lo) switch at the back of the base of the telephone to adjust ring volume.
SPEAKER VOLUME CONTROL
Slide the VOLUME (Hi/Mid/Lo) switch at the back of the base of the telephone to adjust hands-free volume.
FLASH FUNCTION
The FLASH key can be used behind a PABX to transfer calls. To transfer a call to another extension press
the FLASH key followed by the extension number.
NOTE: The flash time must be set to match the PABX flash time (normally 100ms).
LCD BACKLIGHT FUNCTION
The LCD Backlight is turned on upon receipt of an incoming call, dialing, pressing any key or in the music on
hold state. The backlight will automatically turn of after 6 seconds.
Note: Batteries have to be inserted into the battery compartment for this feature to function.
TROUBLESHOOTING TIPS
No Dial Tone * Check hook switch to make sure it pops up
Can‟t dial out * Make sure Tone/Pulse is set to correct position according to telephone
exchange requirement
* Unplug the phone, wait 30 seconds and plug the phone back in
* Check the phone line cord
* Check that all connecors are firmly inserted in their sockets.