Quadro SQ-50E85F, Инструкция по эксплуатации

Страница: 15 / 103

INSERTING BATTERY & CHARGING
BATTERY:
The battery which is initially 50% charged can be used
immediately. Please fully charge/discharge the battery for
the first three times to get maximum capacity.
REMOVE/INSERT BATTERY:
Follow the following steps to remove:
- Opening the back cover by the gap at its upper left side.
- Lift up the battery bottom at its lower side in the direction
of the.
- Close the back cover.
Follow the following steps to install:
- Align the metal contacts of the battery with the metal
contacts in the battery compartment as direction of the,
press the battery bottom into the compartment.
- Put on the battery cover in a parallel way until it is
completely matched.
CHARGE THE BATTERY:
During charging, the battery indicator on the phone is a
thunder icon. If the device is switched off during the charge,
there will still be a charge indication on the screen that
shows the phone is still being charged. If the device is
overused when the battery is low, it might take some time to
appear the charging icon.
When the battery indicator on the screen says 'fully
charged', then thunder icon will disappear, which means
the completion of charging. If the phone is switched off
during charging, the screen will have a 'fully charged' scene.
It generally takes
5 hours to charge the battery. During
charging, the battery, the device and the charger will get
hot. This is normal.
Unplug the charger from the AC electrical outlet and
disconnect the wiring between the phone and the charger
after charging.
Attention: Charge the phone in a well ventilated place in
which the temperature is from-10 ° C to +55 ° C. Use the
charger provided by the manufacturer only. The use of
unconfirmed charger may lead to dangers and violate the
manufacturer's warranty clause. If the temperature is too
high or too low during the charge, the device will
automatically send a warning and stop charging to avoid
damage to the battery or any danger.
ENGLISH
11