Quadratec 92122.203 series, Сборка и инструкция по установке, Страница: 9 / 12

The Trusted Source
®
9
Symptom Possible Cause Suggested Remedy
Motor does not
turn on
Switch assembly not
connected properly Insert switch assembly firmly to the
connector.
Loose battery cable
connection Tighten nuts on cable
connectors.
Solenoid
malfunctioning
Tap Solenoid to free contact, applying 12V
(for 12V motor) or 24V(for 24V motor) to coil
terminal directly. Solenoid will make an audi-
ble clicking when activating.
Defective switch
assembly
Replace switch assembly.
Defective motor
Check voltage at armature port with switch
pressed. If voltage present, replace motor.
Water has
entered motor Drain and dry. Run in short bursts without
load until completely dry.
Motor runs
too hot
long period of
operation
Let winch cool down periodically.
Motor runs slow
or lacking power
battery run down Recharge battery by running vehicle engine.
Insufficient current
or voltage
Clean, tighten or replace connector.
Motor runs but
cable does not turn
Clutch not engaged
Push clutch handle into IN position, if that
does not work, seek professional assistance.
Motor runs in one
direction only
Defective or stuck
solenoid Tap solenoid to free contacts.
Repair or replace solenoid if needed.
Defective switch
assembly
Replace switch assembly.
TROUBLESHOOTING
QSERIES_92112_203X_INSTALL_Layout 1 9/25/12 11:23 AM Page 9
09252012112529