The Trusted Source
®
6
Assembly and Installation
(Continued)
Battery cables SHOULD NOT be drawn taut. Leave slack for some
cable movement. The battery cables SHOULD BE secure, out of
the way of moving parts, road debris, or any possibility of being
damaged by operation or maintenance of vehicle. For example,
the battery cables may be routed under the vehicle, attaching
them to the frame using suitable fasteners such as cable ties
(not included).
DO NOT attach Battery Cables to the exhaust system, drive shaft,
emergency brake cable, fuel line, or any other components which
may cause damage to the battery cables through heat or motion,
or create a fire hazard. If a hole is drilled through the bumper or
any other part of the vehicle, make sure to install a rubber grom-
met (not included) in the hole to prevent fraying of the battery ca-
bles at that point. The use of at least a 650 Cold Cranking Amps
(CCA) battery is highly recommended.
Winch Mounting
Mount the supplied Hawse Fairlead to
the Mounting Frame (not included) using
supplied Bolts and Nuts.
The winch MUST be properly secured to
a winch mount bumper or an approved
winch mount plate with the included
10mm nuts and bolts (qty 4/each). There
are machined pockets at each of the four
inside winch base corners that fit a flange
head whiz nut. Place a nut into each
pocket and center the winch over the
mounting base holes. Tip: a touch of
bearing grease can hold the 4 nuts in
place prior to fastening the flange head
whiz bolts. In some rare mounting
situations drilling for bolt holes may be
required. Thread the four 10mm x 1.5 x
35mm bolts through the bottom of the
winch mount plate or bumper and into
the whiz nuts. Use a torque wrench and
10mm socket and torque each mounting
bolt to 50 Ft-lbs.
Synthetic Winch Line Installation
Your winch has been shipped to you with
the synthetic winch line wound on its
drum for shipping purposes only. Prior to
winch installation, it is necessary to
completely remove and detach the winch
line and re-install it.
The winch hook is not removable and will
not fit through the hawse fairlead. There-
fore, the winch line needs to be threaded
through the fairlead and attached to the
drum once the winch and fairlead are
mounted to the vehicle. The winch line
must then be pre-tensioned.
Do NOT use winch line without pre-ten-
sioning it. First, place clutch in Free
Flange
Head Whiz
Nut (10mm
x 1.5mm)
Flange Head Whiz Bolt
(10mm x 1.5mm x 35mm)
Winch Mount
Plate or Bumper
QSERIES_92112_203X_INSTALL_Layout 1 9/25/12 11:23 AM Page 6
09252012112528
Содержание 92122.203 series
Страница 12: ...The Trusted Source...