Page 31
Yosemite Wood Stove
R
7004-187L
October 13, 2015
4. Cleaning Plated Surfaces
• Frequency:
Prior to first burn and then as desired
• By:
Homeowner
Clean all the fi ngerprints and oils from plated surfaces
BEFORE
fi ring the appliance for the fi rst time. If not
cleaned properly before lighting your fi rst fi re, the oils
can cause permanent markings on the plating.
After the plating is cured, the oils will not affect the
fi nish and little maintenance is required. Wipe clean
as needed.
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
slamming glass.
• Do NOT clean glass when hot.
CAUTION
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white fi lm.
• Use commerical oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently
stain glass on next fi ring.
•
Refer to maintenance instructions.
Glass
Assembly
CAUTION
• Do not use polishes with abrasives.
It will scratch plated surfaces.
5. Glass Cleaning
• Frequency:
As desired
• By:
Homeowner
Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
If the
deposits on the glass are not very heavy, normal glass
cleaners work well. Heavier deposits may be removed
by using a damp cloth dipped in wood ashes or by using
a commercially available oven cleaner.
After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner left on during the next fi ring can permanently
stain the glass and damage the fi nish on plated metal
surfaces.
A portion of the combustion air entering the fi rebox is defl ected
down over the inside of the door glass. This air fl ow “washes”
the glass, helping to keep smoke from adhering to its surface.
When operated at a low burn rate, less air will be fl owing over
the glass and the smokey, relatively cool condition of a low
fi re will cause the glass to become coated.
Operating the appliance with the Primary Air Control all
the way open for 15-20 minutes should remove the built up
coating.
3. Disposal of Ashes
Fire Risk.
Disposal of Ashes
WARNING
• Ashes should be placed in metal container with tight
fi tting lid.
• Do not place metal container on combustible surface.
• Ashes should be retained in closed container until all
cinders have thoroughly cooled.
• Frequency:
When ash is within 1-3/4 in. (44mm) of firebox
lip
• By:
Homeowner
Ashes should be placed in a metal container with a
tight fi tting lid. The closed container of ashes should
be placed on a non-combustible fl oor or on the ground,
well away from all combustible materials, pending fi nal
disposal.
If the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the closed
container until all cinders have thoroughly cooled.
