R
May 12, 2014
7050-128G
Page 21
Santa Fe Pellet Stove
D. Optional Nickel or Black Nickel Grille
Figure 21.1
Heat Exchanger
Rods
Grille Bracket Cover
(shipped flat from factory)
Finger bend into position
after grilles are installed
on appliance
Insert heat exchanger rods
through holes on second grille.
Install in flat position
Bend after grilles installed
Install bottom 3 grilles before
installing single top grille
1. Open the door. Remove the top 2 screws on each side
of upper grille and remove the single grille. Remove the
bottom 2 screws on each side and remove the 3 grilles
attached together.
2. Removing the ash drawer before taking off the lower
grille will make the lower grille easier to remove. Using a
Phillips head screwdriver, remove the 2 screws on each
side and pull forward with a downward motion to avoid
catching the grille on the fi repot pull rod.
NOTE: The plated grilles, Nickel and Black Nickel
have 4 black grille bracket covers to eliminate the
brightness of the bracket plating. The bracket covers
are shipped fl at, installed on the grilles, and after the
grilles are installed on the appliance they are then
fi nger-bent into position.
3. Attach the 4 grille bracket covers to the lower 4 grilles
and the top 3 grilles. Slip the metal strips through the
grille openings and secure to grille with screws provided.
Do not fi nger bend the cover brackets at this time.
4. Secure the lower grille to the appliance with 2 screws on
each side. Finger bend the bracket covers around the
plated brackets.
5. The upper grille has 2 separate parts. Install the 3 grilles
attached together fi rst. Angle the grilles downward and
insert the heat exchanger cleaning rods through the
holes in the second grille and then twist forward until
horizontally level. Attach the grille with only the bottom
2 screws on each side of grille. Do not fi nger bend the
cover brackets at this time.
6. Position the single top grille over the 3 already in place.
Attach with one screw on each side through the top grille
and the other 3 grilles to secure to appliance.
7. Finger bend the bracket covers on the upper grille into
place.
8 Re-install the ash drawer.
Included in Kit:
(4) lower grilles; (3) upper grilles, (1)
upper grille; (4) grille bracket covers; fasteners
Tools Required:
#2
Phillips head screwdriver