Quadra-Fire • QVI-35FB-S • 2178-900 Rev. B • 12/08
9
H. Standing Pilot Ignition
1.
Turn off all electric power to the appliance if ser-
vice is to be performed.
2.
Open control access panel.
3.
Move switch to “OFF” position.
4.
Push in gas control knob slightly and turn clock-
wise
to OFF”.
DO NOT
force.
5.
Close control access panel.
1.
Open control access panel.
2.
Turn off all electric power to
the appliance.
3.
Push in gas control knob
slightly and turn clockwise
to “OFF”.
Note:
Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly.
DO NOT
force.
4.
Open the fi xed glass assembly. You may need to
remove the decorative front.
5.
Wait fi ve (5) minutes to clear out any gas. Then
smell for gas, including near the fl oor. If you smell
gas, STOP! Follow “B” in the Safety
Information located on the left side
of this label. If you don’t smell gas,
go to next step.
6.
Find the pilot. The pilot is inside
combustion chamber next to the
main burner
7.
Turn knob on gas control counterclockwise
to “PILOT”.
8.
Push in control knob all the way and hold in. Immedi-
ately depress red or black piezo button. It may require
several depressions of the red or black piezo button
until PILOT lights. If PILOT light does not light after
10 seconds, return to step 3. Continue to hold the
control knob in for about one minute after the pilot is
lit. Release knob and it will pop back out. Pilot should
remain lit. If it goes out, repeat steps 3 through 6.
•
If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
•
If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your ser-
vice technician or gas supplier.
9.
Reinstall
fi xed glass assembly. Reinstall decorative
front.
10.
Turn gas control knob counterclockwise
to “ON”. Close access panel.
11.
Turn on all electric power to the appliance.
12.
To light burner, turn the wall control or on/off switch
to “ON”.
LIGHTING
INSTRUCTIONS
TO TURN OFF
GAS TO APPLIANCE
464-903H
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING:
If you do not follow these instructions exactly, a fi re or explosion
may result causing property damage, personal injury or loss of life.
CAUTION:
NOT FOR USE
WITH SOLID FUEL
WARNING:
For additional information on operating your
Hearth & Home Technologies fi replace, please refer to www.fi replaces.com.
A.
This appliance has a pilot which
must be lighted by hand. When
lighting the pilot, follow these in-
structions exactly.
B.
BEFORE LIGHTING,
smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
•
DO NOT
try to light any appliance.
•
DO NOT
touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
DO NOT CONNECT 110 VAC TO
THE CONTROL VALVE.
Improper installation, adjustment, al-
teration, service or maintenance can
cause injury or property damage. Re-
fer to the owner’s information manual
provided with this appliance.
This appliance needs fresh air for
safe operation and must be installed
so there are provisions for adequate
combustion and ventilation air.
If not installed, operated, and main-
tained in accordance with the man-
ufacturer’s instructions, this product
could expose you to substances in fuel
or fuel combustion which are known to
the State of California to cause can-
cer, birth defects, or other reproductive
harm.
Keep burner and control compartment
clean. See installation and operating
instructions accompanying appliance.
Hot while in operation.
DO NOT
touch.
Keep children, clothing, furniture, gaso-
line and other liquids having fl ammable
vapors away.
DO NOT
operate the appliance with
fi xed glass assembly removed, cracked
or broken. Replacement of the fi xed
glass assembly should be done by a
licensed or qualifi ed service person.
• If you cannot reach your gas sup-
plier, call the fi re department.
C.
Use only your hand to push in or
turn the gas control knob. Never use
tools. If the knob will not push in or
turn by hand,
DO NOT
try to repair
it, call a qualifi ed service technician.
Force or attempted repair may re-
sult in a fi re or explosion.
D.
DO NOT
use this appliance if any
part has been under water. Imme-
diately call a qualifi ed service tech-
nician to inspect the appliance and
to replace any part of the control
system and any gas control which
has been under water.
For use with natural gas and propane.
A conversion kit, as supplied by the
manufacturer, shall be used to convert
this appliance to the alternate fuel.
Also Certifi ed for Installation in a
Bedroom or a Bedsitting Room.
For assistance or additional informa-
tion, consult a qualifi ed installer, ser-
vice agency or the gas supplier.
Final inspection by