Quadra-Fire • QFP44 • 4051-300 • Rev. U • 4/11
11
Ignitor Battery Box
By pulling the drawer forward, the ignitor battery box can
be accessed to replace the AA battery as necessary. See
Figure 2.4.
Ignitor Battery Box
Figure 2.4
Accessing the Ignitor Battery Box.
G. Remote Operation
This remote control kit has a hand held transmitter that
can be used as a remote on/off or as a thermostat. The
transmitter display shows the current room temperature,
target temperature, timer setting, on/off status, low battery
indicator, current time, burner/valve operation and fan
operation. Electrical ratings for the receiver are: 110 VAC,
60 Hz, 6 W.
Warning!
CHANGES OR MODIFICATIONS TO THIS
UNIT NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses , and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Contact the dealer or an experienced radio TV
technician for help.
Canadian Equipment Requirements
This digital apparatus does not exceed the (Class A/
Class B) limits for radio noise emissions from digital ap-
paratus set out in the Radio Interference Regulations of
the Canadian Department of Communications.
Le present
appareil numerique n’emet pas de bruits radioelectriques
depassant les limites applicables aux appareils nume-
riques (de la class A/de la class B) prescrites dans le
Reglement sur le brouillage radioelectrique edicte par le
ministere des Communications du Canada.
This device complies with RSS-210 of Industry and Sci-
ence Canada. Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, includ-
ing interference that may cause undesired operation of
the device.
FCC REQUIREMENTS
Ignitor Battery Box
By pulling the drawer forward, the ignitor battery box can
be accessed to replace the AA battery as necessary. See
Figure 13.2.
