Quadra-Fire PELLET INSERT CB1200MI-MBK, Руководство пользователя и инструкции по установке

Страница: 27 / 56

R
September 24, 2015
7014-188L
Page 27
1200-I Pellet Insert
H. Thermostat Installation (continued)
The appliance comes standard with a wall thermostat and 25’
of wire. If you need to run more than 25’ make sure you use
a continuous strand of 18 to 22 gauge thermostat wire. For
optimum performance your thermostat should be located on
an inside wall approximately 5’ up from the fl oor.
How to Install Your Wall Thermostat
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart
2. Connect your thermostat wire to the W and R terminals
(see
Figure 27.1 )
3. Screw the backer plate to the wall using the hardware
included
4. Snap the thermostat to the backer plate
5. Connect the wires to the 2 center screws on the terminal
block on the back of the product
Battery Installation and Replacement
NOTE: 2 AA batteries are included with the thermostat
and must be installed before the appliance can be oper-
ated.
Install fresh batteries immediately when the REPLACE
BATTERY warning begins fl ashing. The warning fl ashes
about two months before the batteries are depleted.
Even if the warning does not appear, you should replace
batteries once a year.
If batteries are inserted within two minutes, the time and
day will not have to be reset. All other settings are perma-
nently stored in memory.
Figure 27.1
Figure 27.2
W
R
Press and pull to remove