October 12, 2015
7075-205B
Page 25
Voyageur Grand
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2
. Lay surround face down on a protected surface to prevent
scratching.
3. Using a 102 to 152 millimeters long Phillips head screw
driver attach the side surrounds to the top surround using
(2) #8 sheet metal screws on each side provided with the
kit
4
. Place the peel and stick round felt vibration insulation pads
on the front side in each corner of the top metal piece and
on the back side in each corner of the top cast piece.
Figure
22.1.
5. Place the corresponding cast trim pieces (2 cast trim sides
and 1 cast trim header) underneath the panel set, also face
down. Align the holes in the metal pieces with the 5 bosses
on the top cast piece and 2 bosses on each side piece.
6. Secure the magnet to the bracket and attach the magnet and
bracket to each metal side piece at the bottom. The magnet
Included in Surround Kit:
(2) side pieces, left and right; (1)
l top piece; (1) fastener package.
Included in Cast Trim Kit:
(2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed:
Powered 102 to 152 millimeters long Phillips
head screw driver; pliers
G. Standard Surround & Cast Trim Kit
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Figure 22.1
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
is facing the front.
Figure 22.2.
7. Place the cast footers under the metal sides aligning the top
and bottom holes in the cast footers and metal sides.
8. The 9 mounting clips are shipped in one long strip. Hand
break apart or use pliers.
9. Each clip has a clearance notch to allow room for the cast
on the insert. Place the clip so the notch is facing the outer
edges of the surrounds.
Figure 22.3.
10. It is best to install all of the 1/4-20 screws only half way at
fi rst to allow for adjustments. After adjustment, tighten the
2 screws in each cast footer fi rst and then work your way
around to the rest.
11. Slide surround and trim over the top of the insert into place
matching the mounting tabs on the metal sides with the slots
on the insert.
Figure 22.4
.
12
. Align the 2 screws in the top metal surround piece to the
2 alignment holes on the appliance top. Secure in place.
Figure 22.4.
Figure 22.2
Figure 22.3
Match Mounting
Tabs to Slots on
the appliance
Figure 22.4
Standard Size: 1080 mm. W x 762 mm H
Large Size: 1219 mm W x 864 mm H
