7095-819
22
Quadrafire • Expedition II AU Owner’s Manual_Rev B • 2020 - ___ • 03/21
C. Blower
Service Part: SRV7000-868
1. Ensure that the fire is out and the appliance is cool to
the touch.
2. Remove the door by lifting the door up and off of the hinges;
set aside
(Figure 5.3)
.
3. Remove the fascia by lifting up and off of the appliance;
set aside
(Figure 5.3)
.
4. Disconnect the wires from the blower
(Figure 5.4)
.
5. Remove the 2 screws from the hold down bracket and pull
the blower and bracket forward.
6. Remove the blower from the hold down bracket.
7. Re-install in reverse order. Be certain that the hold down
bracket’s screws are completely seated in the grommets.
Insert the locating tab in the hold down bracket into the
placement slot.
D. Snap Disc
Service Part: SRV230-0470
1. Ensure that the fire is out and the appliance is cool to
the touch.
2. Remove the door by lifting the door up and off of
the hinges; set aside
(Figure 5.3)
.
3. Remove the fascia by lifting up and off of the appliance;
set aside
(Figure 5.3)
4. Remove snap disc box from lower left.
5. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and lift the snap disc off of the
mounting bracket
(Figure 5.5)
.
6. Disconnect the wires and replace with new snap disc
and re-connect the wires.
7. Place snap disc box back in position and reassemble
fascia and door.
Shock Risk.
•
Do NOT remove grounding prong from plug.
•
Plug directly into properly grounded 3 prong
receptacle.
•
Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
CAUTION
!
Figure 5.3
Figure 5.4
Figure 5.5
