22
July 30, 2019
7095-802B
EXPEDITION II INSERT
Clearance Notch
Figure 22.3
Top:
over lip on
top of appliance
Sides:
through cut outs on sides and
then down
Figure 22.4
6.
Place the cast footers under the metal sides aligning
the top and bottom holes in the cast footers and
metal sides.
7.
The 9 mounting clips are shipped in one long strip.
Hand break apart or use pliers.
8. Each clip has a clearance notch to allow room for the
cast on the insert. Place the clip so the notch is facing
the outer edges of the surrounds
(Figure 22.3)
.
9.
It is best to install all of the 1/4-20 screws only half
way at first to allow for adjustments. After adjustment,
tighten the 2 screws in each cast footer first and then
work your way around to the rest.
10. Slide surround and trim over the top of the insert into
place matching the mounting tabs on the metal sides
with the slots on the insert
(Figure 22.4)
.
11.
Align the 2 screws in the top metal surround piece to
the 2 alignment holes on the appliance top. Secure in
place
(Figure 22.4)
.
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnets
before installing
Cast Footers
Front View:
Magnet Installed
Cast Footers:
Left & Right
Figure 22.1
Front of
Surround
Attach magnet like shown above
Figure 22.2
H. Standard Surround & Cast Trim Kit
1.
Remove contents from box being careful not to scratch
or damage the cast trim pieces.
2. Lay surround face down on a protected surface to
prevent scratching.
3.
Place the peel and stick round felt vibration insulation
pads on the front side in each corner of the top metal
piece and on the back side in each corner of the top
cast piece
(Figure 22.1)
.
Overall Dimensions
Part Number
Standard
Surround
43” x 31”
CT2-4331
Large
Surround
51” x 34”
CT2-5134
Cast Trim Kit
Fits both standard
and large surrounds
811-0930
4.
Place the corresponding cast trim pieces (2 cast trim
sides and 1 cast trim header) underneath the panel set,
also face down. Align the holes in the metal pieces with
the 5 bosses on the top cast piece and 2 bosses on
each side piece.
5.
Secure the magnet to the bracket. The magnet is
facing the front
(Figure 22.2)
.
Table 22.1
