Quadra-Fire CASTILE Series, Руководство пользователя, Страница: 27 / 42

27 February 5, 2019 7022-515I
CASTILE INSERT
Brick is flush against back wall
Notches
exposed
C. Re-installing Baffle & Brick Set
1. Place right brick in behind the right bracket, and then
slide to the left so the tabs are behind the center brick
( Figure 27.4).
2. The brick will be flush against the back wall and notches
exposed in the side bracket ( Figure 27.5).
3. Lift slightly and pull the right edge of the brick forward
until it stops and then drops down into both top and
bottom notches of right bracket and locks into place
( Figures 28.1 and 28.2).
4. Repeat for left brick.
5. Insert baffle into top front inside the firebox and pull
forward. Then raise up the bottom end and insert
baffle tab into slot on the top of the right bracket to lock
into place ( Figure 27.3). Place the left side hook at
the bottom of the baffle over the top edge of brick for
stability ( Figure 27.4).
6. The baffle does not completely cover the top of the
firebox. There is an opening on the left as shown in
Figure 27.5.
Tabs
Figure 27.4
Figure 27.5
B. Baffle & Brick Replacement
1. Follow proper shutdown procedures in Section 10.
2. The top baffle has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffle by first pulling the baffle forward
until back edge drops down. Then slide baffle back until
the front edge clears the shelf that it had been resting
on ( Figure 27.1).
3. The top baffle must be removed before you can remove
the right and left brick. Remove the right brick by holding
top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is flush with the
firebox. Rotate the inside edge of the brick forward and
remove brick. Repeat for left brick ( Figure 27.2).
Remove Right
& Left Brick
Hook on
left side
Tab on
right side
Vacuum
Exhaust Area
Right Brick
Removed
Figure 27.1
Figure 27.2
Figure 27.3