16 August, 2018
7038-248A
16
5700 Step Top AU Wood Appliance
Included in Kit
:
ARS door assembly, ARS latch assembly, Pedestal, Ash
Pedestal Drawer, ARS Channel, ARS Cover, and fastener
package.
Tools Required:
7/16 socket wrench, 3/8 open end wrench, Phillips screw
driver, and hammer.
NOTE:
The Ash Removal System, must be installed first
before installing the pedestal.
A. Pedestal Assembly & Ash Removal System
Installation
Remove 3 bricks for
installation and then re-install
Figure 16.1
Loosen
X4
Remove
X8
Remove
& discard
Heat
shield
Gasket
Knock out
& discard
X
6
4
5
5
7
Figure 16.2
Figure 16.3
Slot to slide rod of Ash
Door Assembly through
8 threaded
studs
Ash Door
Assembly
Begin installing the ARS System.
1.
Remove leg mount brackets packaged inside of firebox
and discard.
2.
Remove the 3 bricks in the front most part of the firebox
(Figure 16.1)
.
3.
Lay appliance on its back on a protective pad or pallet
(Figure 16.2)
.
4.
Remove heat shield by loosening the four bolts using
3/8 open end wrench
(Figure 16.2)
.
5. Remove 8 nuts that hold the cover plate on using a
7/16 socket wrench; discard cover plate
(Figure 16.3)
.
6.
Remove knock out from bottom of firebox by using a
hammer
(Figure 16.2)
.
7.
Install ash door assembly by sliding the rod at an angle
into the slot on the left side
(Figure 16.3)
.
8. Slide the ash door over the 8 screws protruding from
the bottom of the appliance. Secure with nuts and
washers using 7/16 socket wrench
(Figure 16.3)
.
5
Appliance Set-Up
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
WARNING
