Page 10
7038-201D
October 12, 2015
5700 Step Top ACC Wood Burner
1. Unpack the Flue Mounted Shield, detach the three brackets and familarize yourself with the illustra-
tions.
2. Using a sharp knife or razor blade, carefully cut through the plastic
fi
lm on the “inside face” where
it meets the outer shield (refer sketch). Cut along the full length of the Flue Mounted Shield on both
side, then peel off and fully remove the plastic
fi
lm from the stainless steel inner shield.
3. Peel back and fully remove the plastic
fi
lm from the outer shield.
4. Fit the top bracket to the Flue Mounted Shield as illustrated ensuring the rear mid section of the
bracket
fi
ts “outside” while the two outer sections of the bracket
fi
t “inside”.
5. Fit the appropriate lower bracket to your wood
fi
re.
Lower Bracket “5B suitable for all other wood
fi
res without an inner rear heatshield. On certain model
wood
fi
res without a raised
fl
ue spigot it will be necessary to cut off both the lower outer legs from the
bracket “5B” leaving the entral tongue to locate inside the
fl
ue outlet only.
Two tabs are provided and if folded back at 90 degrees the bracket and Flue Mounted Shield will
mount lower onto the appliance.
The Flue Mounted Shield then locates into the two notches provided n bracket “5B” as illustated.
6. Once the Flue Mounted Shield is
fi
tted in position onto either of the two lower mounting brackets,
check to ensure a large gap is not present between the top of the wood
fi
re and the base of the Flue
Mounted Shield, as this may result in a hot spot on the rear wall directly behind the
fl
ue outlet. If your
wood
fi
re has a lift off top grill the Flue Mounted Shield should be raised suf
fi
ciently to enable the top
grill to be removed.
7. Using the pre-punched holes in the two tabs provided on the top bracket as guides, drill into the
fl
ue pipe and secure the top bracket to the
fl
ue pipe with two stainless steel rivets (not supplied).
GENERAL INSTRUCTIONS FOR FLUE SYSTEM
MINIMUM HEIGHT OF FLUE SYSTEM EXIT
Fig. 8
3000
3000
or less
More than 3000
600 min.
3000
increase as necessary
until nothing within
3000mm of flue top
Any nearby structure
increase from 1000mm
minimum until clear within
3000mm of flue top
