4.
Open the water tank cover and add water or distilled water to the reservoir ensuring
you
don’t
fill over the recommended fill line.
5.
Connect the wired digital control panel to the socket marked
“
Remote Control
”
on the
rear panel.
6.
If DMX is to be used for control, connect the DMX signal from the controller to the
DMX IN XLR connector. Any further DMX controlled units may be connected via the
DMX OUT XLR connector.
7.
Connect the IEC mains plug and power the unit on.
8.
The unit will begin the warming up process which normally takes around 3-5 minutes.
Operation:
The LCD panel on the wired digital control panel will display the following outputs:
Function
Selection
Content
Heating status
Warming up
Unit is warming up please wait
Ready to fog
Unit is ready to use
Manual volume adjust
Set 1-100
Set manual fog output low to high
Interval
Set 1-900
Set continuous fog intervals low to high
Duration
Set 1-200
Set continuous fog duration
Volume
Set 1-100
Set continuous fog output low to high
Wind
Set 1-100
Set fan speed low to high
DMX512
Set 1-512
Set required DMX address
If the unit is set to DMX mode (d001-d512), the unit will operate by DMX control as follows:
Channel
Value
Content
CH1
0-255
Fan speed 0-100%
CH2
0-255
Fog output 0-100%
RF Remote Control:
The small RF remote control supplied can also be used when wireless control of the unit is
needed. Ensure the wired digital control panel is connected to the unit, to use the remote for
the following functions:
A
: Continuous fog stop
B
: Continuous fog start
Up arrow
: Fog increase
Down arrow
: Fog decrease