Single colour
The unit can be set to produce one of 7 preset static colours with or without a strobe effect.
It is recommended that the strobe effect be disabled during colour selection as follows.
•
Press MENU repeatedly until the display shows
(refer to appendix 1) followed
by ENTER.
•
Using the UP and DOWN buttons select
from the sub menu followed by
ENTER.
•
The display will show the colour number which will be between
and
.
•
Using the UP and DOWN buttons select
from the sub menu followed by
ENTER.
•
The display will show the strobe speed from
(disabled) to
(fast).
•
Using the UP and DOWN buttons select
to disable the strobe followed by
ENTER. The display will then show
again.
From this point the required colour can be set as follows:
•
Using the UP and DOWN buttons select a colour number between
[
]
and
followed by ENTER. The display will show
.
•
Press and hold MENU for 5 seconds to save the program.
To reinstate the strobe function following colour selection repeat the above routine
changing the strobe speed from 0 to the required value.
In addition, custom colours can be produced via the manual
setting in the main menu
(refer to appendix 1).
To set a custom colour:
•
Press MENU repeatedly until the display shows
(refer to appendix 1) followed
by ENTER.
•
The display will show
.
•
Press ENTER if red is the colour to be changed or use the UP and DOWN buttons to
select a different colour, followed by ENTER.
•
The display will show a number between
and
.
•
Use the UP and DOWN buttons to set the required intensity followed by ENTER.
•
Use the UP and DOWN buttons to select another colour if required followed by
ENTER.
•
Change the intensity as detailed above followed by ENTER.
•
Press and hold MENU for 5 seconds to save the settings.
