USER MANUAL
13
CONTROL & FUNCTION
z
Regular breaks during operation are essential to maximize the life of this
device as it is not designed for continual use.
z
Do not switch the unit on and off in short time intervals
z
Always unplug the unit when it is not used for a longer time. Or before
replacing the bulb or start servicing.
z
In the event of serious operation problems, stop using the fixture and
contact your dealer immediately.
Attention
Laser will be output from laser aperture in 5 seconds
after the unit is powered on.
MAINTENANCE
z
Make sure the area below the installation place is free from unwanted persons
during servicing
z
Switch off the fixture, unplug the mains cable and wait until the unit has been
cooled down.
z
Housings, fixations and installations spots( ceiling, truss, suspensions) should
be totally free from any deformation
z
The mains cables must be in impeccable condition and should be replaced
immediately when even a small problem is detected
z
In order to protect the fixture from overheat the cooling fans (if any) and
ventilation openings should be cleaned monthly.
z
The cleaning of aperture glass and scanner mirrors must be carried out
periodically to optimize light output. Cleaning frequency depends on the
environment in which the fixture operates: damp. smoky or particularly dirty
surroundings can cause greater accumulation of dirt on the unit’s optics
1)
Clean with a soft cloth using normal glass cleaning products.
2)
Always dry the parts carefully.
3)
Clean the Aperture glass at least once every 30 days
z
The interior of the fixture should be cleaned annually using a vacuum cleaner
or air-jet.
ATTENTION: We strongly recommend internal cleaning to be carried
out by qualified worker!
