Installation Manual
3. Product Installation
24
www.qtech.ru
2.
Check whether the power cord container is correctly installed. If you can remove the strap
without pressing buckle A, the strap may be installed incorrectly. Try the other side of the
strap.
3.
Attach the power cord container to the installation hole of the power module.
4.
Plug the power cord into the connector. Pass the power cord through the strap and adjust
the ring by pressing buckle B until the power cord is fastened.
Figure 3-9 Installing Power Cord Retainer
Removing a Power Module
1.
Press the plug of the power module, Hold on to the module handle with one hand to pull out
part of the module, hold the bottom of it with the other hand, and pull out the power module
uprightly and slowly.
2.
Install a filler panel in the power module slot and put the removed power module into its
package.
