Руководство пользователя
1. Configuring WAN-4G
18
www.qtech.ru
③
: The SIM card is locked after replacement. In this case, the corresponding PUN code of SIM card can
be used to unlock it. Refer to the description about the PUK unlocking scenario.
Example: Configure PIN code protection (in router binding mode; the configuration for other modes is similar).
Qtech(config)#interface cellular 0/0
Qtech(config-if-Cellular 1)# plmn pin-protection bind-router 0 1234
uijie(config-if-Cellular 1)# show running-config interface cellular 0/0
Building configuration...
Current configuration : 65 bytes
!
interface Cellular 0/0
plmn pin-protection bind-router 0 1234
1.2.9.2
Changing PIN Code
Use the PIN code changing command to change the PIN code if required.
Command
Description
Qtech# configure terminal
Enters the global configuration mode.
Qtech(config)# interface cellular 0/0
Enters the interface configuration mode.
Qtech(config-if-Cellular 1)# plmn pin-protection simple 0
1234
Enables the simple PIN code protection function. The
last numeric string in configuration is the PIN code
corresponding to the SIM card.
Qtech(config-if-Cellular 1)# plmn modify 2345
Changes the PIN code.
1. The PIN code changing command can only run in the simple mode.
2. To run this command, judge the modem status. Therefore, the PIN code changing command may
fail if the modem status is abnormal. A prompt message is displayed in the system log, and the user
can try again later. The PIN code may also be changed through a mobile phone.
3. Command execution may fail if the operator
’s network is busy or due to other factors.
4. Use this command with caution. When this command is used, it is necessary to save the existing router
configuration.
Example: Configure PIN code protection (in router binding mode; the configuration for other modes is similar).
Qtech(config)#interface cellular 0/0
Qtech(config-if-Cellular 1)# plmn pin-protection bind-router 0 1234
Qtech(config-if-Cellular 1)# plmn modify 2345
Proceed with modify pin code and write config?[N0] y
pin code modify success !
Qtech(config-if-Cellular 1)# show running-config interface cellular 0/0
Building configuration...
Current configuration : 65 bytes
!
interface Cellular 0/0
plmn pin-protection bind-router 0 2345
1.2.9.3
PUK Unlocking
The SIM card will be locked when a wrong PIN code is used to enabled PIN code protection. In this case, PUK
unlocking is needed, and a new PIN code needs to be set for the SIM card. When the SIM card is in the PUK locking
status, the user will be prompted using the system log printing form, and the user can use the sh cell info command
to view the SIM card status.
Command
Description
Qtech# configure terminal
Enters the global configuration mode.
Qtech(config)# interface cellular 0/0
Enters the interface configuration mode.
Qtech(config-if-Cellular 1)# plmn puk-unlock 12345678
1234
PUK unlocking; the first character string is the PUK code
and the second character string is the new PIN code.
1. The PUK unlocking is required in the following cases:
Содержание QSR-2830
Страница 1: ...www qtech ru QSR 2830...
