QTech QSR-2830, Руководство пользователя

Страница: 15 / 28

Руководство пользователя
1. Configuring WAN-4G 15
www.qtech.ru
1.2.8
Anti-traffic-impact
1.2.8.1 Configuration Steps
Step Configuration Task Description
1. Configure the ACL for limiting traffic. Mandatory.
2 Configure the anti-traffic-impact function. Mandatory.
1.2.8.2
Configuring Anti-traffic-impact Function
Command Description
Qtech# configure terminal Enters the global configuration mode.
Qtech(config)# ip access-list extended 109 Configures the ACL that limits traffic of video servers.
Qtech(config-ext-nacl)# deny ip any host 192.168.50.246 Limits traffic destined for a specified destination address.
Qtech(config-ext-nacl)# permit ip any any Allows other traffic.
Qtech(config)# interface cellular 0/0 Enters the interface configuration mode.
Qtech(config-if-Cellular 1)# apply detect interface vlan 10
{bfd | track track_id} Configures protocol state association between the 4G
link and primary link: BFD or TRACK.
Qtech(config-if-Cellular 1)# apply traffic-anti-impact
interface VLAN 1 list 109 Configures the anti-traffic-impact function.

1. Configure protocol state association of the primary interface to perform dialing on demand.

The anti-traffic-impact function is supported only on 4G mobile routers of the RSR820 series.
Example: Configure dialing on demand and set the dialing delay from 1s to 60s.
Qtech(config)#interface cellular 0/0
Qtech(config-if-Cellular 1)# apply detect interface vlan 10 bfd
Qtech(config-if-Cellular 1)# a apply traffic-anti-impact interface VLAN 1 list 109
Qtech(config-if-Cellular 1)# show running-config interface cellular 0/0
Building configuration...
Current configuration : 65 bytes
!
interface Cellular 0/0
apply detect interface vlan 10 bfd
apply traffic-anti-impact interface VLAN 1 list 109
Qtech#