QSC USL JSD-60, Руководство пользователя

Страница: 14 / 44

184050 Page 14
Front Panel Interface
•
Eight buttons: COAX, TOSLINK, DIGITAL 8 CH, OPTION, ANALOG 6 CH, NON/SYNC, MIC, and
MUTE.
•
Main Fader – 0–10 used for main audio and bypass audio.
• Front panel displays fader level and selected format. Bar graph displays output levels
including high and low bands when operating in bi-amp.
• USB connector.
• Power switch and power supply status LEDs. Turning power off activates bypass mode.
Format Selection
•
Digital (COAX, TOSLINK, eight Channel AES/EBU).
•
Analog (6 channel, Non-Sync, and Microphone).
•
Option (Configurable in software, e.g., digital 8 channel, COAX, TOSLINK, analog six channel,
Non/Sync, and microphone).
Rear Panel Connectors – Main Chassis
•
PA/Calibration Microphone – XLR / ¼" phone jack.
•
Six Channel Analog – DB25F.
•
Non/Sync – two RCA jacks.
•
Hearing Impaired and Visually Impaired - Narrative – pluggable Phoenix connector.
•
COAX – RCA jack with transformer input
•
TOSLINK – Optical.
• 8 Channel Digital AES/EBU – DB25F and RJ45.
• Removable Memory Card – SD compatible.
• Serial Control – RS-232 on DB9F.
•
Pulse Automation – DB25F.
• 10/100M Ethernet – RJ45.
•
DC 12V Power Connector – 5 mm with 2.5 mm pin.
•
AC Power – IEC socket. 100-240 VAC, 50/60 Hz, 18 W typical.
•
Eight Channel Audio Output - DB25M. Eight balanced outputs for full range or low band (if
crossover option installed).
•
Crossover Audio Output - DB25M (crossover option only). Balanced outputs for left, center,
and right high band plus LFE2.
•
AES/EBU Audio Output – Two RJ45 connectors (AES/EBU output option only). Six AES/EBU
pairs: left low, left high, center low, center high, right low, right high, Ls, Rs, Lrs, Rrs, LFE,
LFE2. When bi-amp mode not selected, low band outputs become full range.
•
BLU link Audio Output – Two RJ45 connectors (BLU link option only). Drives 96 kHz BLU link
loop as master providing left low, left high, center low, center high, right low, right high, Ls,
Rs, Lrs, Rrs, LFE, LFE2. When bi-amp mode not selected, low band outputs become full
range.