5
TD-000536-00-A
Third-party Brackets
Refer to
— Figure 5
.
WARNINNG!:
Be sure to use a
safety cable as described in
"Safety Cable" on page 3
.
The back panel of the enclosure has ten
mounting points, that conform to the standard
2.75 x 5.0 inch hole mount pattern. These ten
mounting points allow you to use a standard
4-hole bracket in one of four locations. If you use
a multi-mount wall bracket you can get more
horizontal pan by using the outer set of threaded
inserts toward the direction of the panning.
1. Use a Phillips screwdriver to remove the pre-installed bracket, part (1), on
— Figure 2
.
2. Install your selected mounting bracket according to the manufacturer's instructions. Be sure to replace screws into any unused holes. (
— Figure 5
)
Loudspeaker Connections
The SR-1590 has a 4-position screw-type barrier strip, which accepts up to 10-gauge (10 AWG) bare wire or spade lugs. Be sure to maintain consistent
polarity from the amplifier to the loudspeaker’s input terminals.
You can wire each loudspeaker individually ("home-run") a single amplifier channel or, you can wire the loudspeakers in parallel (daisy-chained).
However, since the SR-1590 is a 4
Ω
loudspeaker, we recommend wiring each loudspeaker individually to a single amplifier channel.
IMPORTANT!:
Be sure to check the amplifier’s specifications for load requirements when you wire loudspeakers in parallel.
Make sure you maintain the proper polarity from the amplifier to each of the loudspeakers you connect.
1. Connect the wires from the amplifier
–
and
+
to the
–
and
+
INPUTS of the loudspeaker's barrier-strip connector.
2. Make sure the wires are secured to the connector.
3. Secure the wires with the proper strain relief as needed.
4. If you are connecting loudspeakers in parallel (daisy-chain), connect the wires to the
–
and
+
to the
–
and
+
OUTPUTS of the loudspeaker's barrier
strip connector, and the other ends to the
–
and
+
to the
–
and
+
INPUTS of the next loudspeaker's barrier strip connector.
— Figure 5 —
— Figure 6 —
INPUT
-
+
-
+
OUTPUT
INPUT
-
+
-
+
OUTPUT
Amplifier
