3
TD-000536-00-A
Introduction
The SR-1590 is a high-power, compact cinema surround loudspeaker that addresses the requirements of the new immersive sound formats.
The SR-1590 is designed for safe and secure overhead mounting:
• Pre-installed hardware allows fast single-installer wall mounting with optional wall brackets supporting down-angles of 0° or 8°.
• A traditional U-bracket or yoke (YM-500) is also available.
• The rear panel of the cabinet has ten M6 threaded insert mounting points that accommodate the standard bolt pattern for most third-party bracket
manufacturers.
• Four of the mounting points are centered on the cabinet’s rear panel allowing the use of a multiple angle aiming bracket.
SR-1590 Package Contents
Installing the SR-1590
WARNINNG!:
Read and follow these instructions carefully. If the loudspeakers are not suspended properly, they could fall,
causing personal injury and damage to the equipment.
Rules for Suspension
1. Consult a Professional Mechanical or Structural Engineer, licensed in the jurisdiction of the sound system installation, to review, verify, and approve
all attachments to the building or structure.
2. Employ the services of a Professional Rigger for hoisting, positioning, and attaching the equipment to the supporting structure.
3. Correct use of all suspension hardware and components is imperative in sound system suspension and deployment.
4. Always calculate suspended loads before lifting to make sure suspension components and hardware are used within their respective load limits.
5. Consult local codes and regulations to fully understand the requirements for suspended loads in the venue in which you will suspend the
equipment.
6. Use only the recommended brackets with the M8 and M6 installation points.
7. Be absolutely certain of the integrity of any structural member intended to support suspended loads. Hidden structural members can have hidden
structural weakness.
8. Never assume anything! Owner or third-party supplied suspension attachment points may not be adequate for suspending the loads.
Safety Cable
WARNINNG!:
For any overhead installation, you must use safety cables (not included)
attached to the supporting structure and the loudspeaker enclosure.
Refer to
— Figure 1
1. Install the included M6 threaded shoulder eyebolt (2) into one of the unused M6 threaded inserts on
the back of the enclosure.
2. Attach one end of the safety cable (1) to the support structure, and the other end to the eyebolt on
the loudspeaker enclosure.
IMPORTANT!:
All 12 threaded inserts must have fastening hardware (screws or eyebolt)
securely installed. The insert holes are open into the enclosure. If a hole is left open it
creates an air leak and the performance of the loudspeaker will be compromised. If the hardware is not securely installed it may rattle
and/or fall out.
1 SR-1590 Loudspeaker
1 User Guide
1 M6 Eyebolt
Warranty TD-000453
— Figure 1 —
1
2
