2
TD-000541 -01-B
Connections and Controls
Front Panel
1. STATUS LED –
◦
Green LED
◦
Off indicates the camera is in STANDBY mode,
network streams are off.
◦
On indicates the camera is streaming video over
the network.
◦
Blinking indicates the ID mode is on
2. POWER LED -
◦
Blue LED
◦
On indicates the camera has power applied
◦
Off indicates the camera has no power applied
Rear Panel
1.
Label
◦
Model: PTZ-12x72 or PTZ-20x60
◦
MAC Address
◦
Serial Number (on the bottom of the unit)
2.
ID Button
– Press to identify this piece of
equipment in Q-SYS Designer, and Confi gurator. The
green STATUS LED, on the front panel, blinks when
in ID mode.
3.
FACTORY RESET pin-hole
– Use a paperclip or
similar object to insert and press and hold the reset
button for 5 seconds. This resets all parameters to
the factory defaults.
4.
Kensington
™
Lock slot
– Security cable not supplied.
5.
LAN / POE
– Q-SYS Gigabit Ethernet port / CAT5e
or better / RJ45 / connect to the Q-LAN
™
network
switch with Power over Ethernet
6.
HDMI
– Camera output to various video formats setup
by the users through Q-SYS Designer or a Q-SYS UCI
(User Controlled Interface)
NOTE:
When a video format is selected,
it is used by both the HDMI and
3G SDI outputs.
7.
3G SDI
– Camera output to various video formats
setup by the user. Setup is through Q-SYS Designer
or a Q-SYS UCI
8.
SERVICE
– No user-accessible functionality.
9.
DC 12 V
– Connect an external power supply (not included). Supply to be rated at 12 V / 1 A, center-pin positive, outside barrel
negative. Use only a Class 2 / LPS Power Supply.
— Figure 1 —
STATUS
POWER
2
1
— Figure 2 —
2
1
3
4
5
6
7
8
9
