3
Cleaning
WARNING
: Liquids entering the housing may damage the internal electronics. Keep liquids away and do not use any solvents or
chemicals to clean this product.
The NM-T1 grille may collect dust and small debris over time. Use only a solvent-free damp cloth or small vacuum intended for use with
electronics to clean the NM-T1control ring and grille. The vacuum should be used with a soft bristle attachment to minimize the force of air
drawn directly through the microphone grille. Do not use compressed air to clean the NM-T1.
FCC Statement
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
Environmental
•
Expected Product Life Cycle
: 10 years
•
Storage Temperature Range
: -20°C to +70°C
•
Relative Humidity
: 5 to 85% RH, non-condensing
RoHS Statement
The QSC Q-SYS NM-T1 is in compliance with European Directive 2011/65/EU – Restriction of Hazardous Substances (RoHS2).
The QSC Q-SYS NM-T1 is in compliance with “China RoHS” directives per GB/T 26572. The following chart is provided for product use in
China and its territories:
QSC Q-SYS NM-T1
部件名称
(Part Name)
有害物质
(Hazardous Substances)
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr(vi))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
电路板组件
(PCB Assemblies)
X
O
O
O
O
O
机壳装配件
(Chassis Assemblies)
X
O
O
O
O
O
本表格依据 SJ/T 11364 的规定编制。
O: 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。
X: 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。
（目前由于技术或经济的原因暂时无法实现替代或减量化。）
This table is prepared following the requirement of SJ/T 11364.
O: Indicates that the concentration of the substance in all homogeneous materials of the part is below the relevant
threshold specified in GB/T 26572.
X: Indicates that the concentration of the substance in at least one of all homogeneous materials of the part is above the
relevant threshold specified in GB/T 26572.
(Replacement and reduction of content cannot be achieved currently because of the technical or economic reason.)
