Installing the System Hardware
37
CAUTION:
If you change the host card type in the same slot, the system needs to
be reset to factory default to make the host card change effective. If
you want to learn more about how to reset your system to factory,
please refer to the chapter 6.5.5, Rest to Factory Default section in the
XCubeSAN SANOS 4.0 User’s Manual
All dual controller XCubeSAN series models must have installed the
same type of host cards into the same slot number to keep the
optimized system performance.
INFORMATION:
Due to the total bandwidth of slot 2 is 20Gb. It CAN NOT satisfy four
ports of 10GbE iSCSI with full speed, we strongly recommend
combining two ports by enabling link aggregation for failover. Such as
combining port 1 and port 2 as LAG (Link Aggregation Group) 1, port 3
and port4 as LAG 2. If you want to learn more about how to setup link
aggregation, please refer to the chapter 7.3.1, Configure iSCSI Ports
section in the
XCubeSAN SANOS 4.0 User’s Manual
Procedures of the Host Card Installation
The following content and images are detailed steps for installing a host card into the
system.
Remove the controller from the system chassis.
The following image and table are the introduction of the mechanical components of a
controller module.
Содержание XCubeSAN XS5224D
Страница 10: ...viii Copyright 2017 QSAN Technology Inc All Right Reserved Appendix 114 End User License Agreement EULA 114...
Страница 121: ...Quick Maintenance 103 Figure 6 21 Example of a Failed Power Module Figure 6 22 Example of a Failed Flash Module...
Страница 125: ...Support and Other Resources 107 Figure 7 1 Download Service Package in the SANOS UI...
Страница 129: ...Support and Other Resources 111...