86
Copyright@2004~2014 Qsan Technology, Inc. All Rights Reserved.
Qsan Document – User Manual
F630Q:
2 x GbE iSCSI ports per controller.
These network ports must be assigned IP addresses then they can be used. For better
performance or fault tolerance reason, they can be bonding as Trunking or LACP. These bonding
network ports share a single IP address. The following example shows the P400Q series (6 x GbE
iSCSI ports).
This figure shows six iSCSI data ports. These data ports are set up with a static IP address. For the
other controllers, that can be set up the same way.
The options are available on this tab:
▼
->
iSCSI Bonding Settings:
The default mode of each iSCSI data port is individually
connected without any bonding. Trunking and LACP (Link Aggregation Control Protocol)
settings can be setup here. At least two iSCSI data ports must be checked for iSCSI bonding.
。
Trunking:
Configures multiple iSCSI ports to be grouped together into one in order to
increase the connection speed beyond the limit of a single iSCSI port.
。
LACP:
The Link Aggregation Control Protocol is part of IEEE specification 802.3ad that
allows bonding several physical ports together to form a single logical channel. LACP
