Qsan Technology XCubeNXT XN8012D, Руководство по оборудованию

Страница: 54 / 69

50 © Copyright 2018 QSAN Technology, Inc. All Rights Reserved.
8. Buzzer Indicator Table
Number Beep Sound No. of Times Description
1
Short beep
(0.5 sec)
1

The XCubeNXT is ready (finish start up).

The XCubeNXT is being shut down
(software shutdown).

The user presses the reset button to
reset the storage.

The system firmware has been updated.

USB drive is removed.

The user starts hard drive rebuilding.
2
Long beep
(1.5 sec)
Beep until
event finishes,
interval of 0.5
sec

1) The system pool has reached its full
capacity (100%). 2) The system pool is going
to be full (95%). 3) The system fan is out of
function. 4) A bad sector is detected on the
hard disk drive or hard disk failed. 5) One of
the pool is in degraded mode. 6) Hardware
self-test error.
e.g. PSU failed, abnormal
voltage, the temperature is at critical
high/low, any cooling fan module failed or
removed, any pool failed.
Note: If one event has triggered the beep sound, the next event will not trigger the beep sound
until the previous event has finished.
Note 2: The beep sound will not be triggered if buzzer function is disabled from the QSM. You can
check the error messages through the Notification Center on QSM.