33
Recommended place for removing the controller module: the system is in a
well secured rack or on a stable surface.
2. The controller must be installed into slot 1 (the top slot of the system from the
rear view).
1.
Remove the controller from the system chassis.
Loosen the screws below the release lever on the back of the XCubeNXT. Pull
down both release lever at the same time, then pull out the controller.
Use one hand to hold one end of the controller module (the side with release levers) and the
other hand hold the bottom of the controller. Pull out the controller module until it is free from
the system chassis.
2.
Prepare a new controller module, insert back to the system chassis.
Align the controller with the chassis, then gently push the controller all the way to the back.
Push back and release lever then fasten the screws on the back of the XCubeNXT.
Содержание XCubeNXT XN8000D
