QRS Presto Digitation 73200, Инструкция по установке и эксплуатации

Страница: 8 / 16

Page 8 Presto Digitation Installation Manual
align evenly
Example: If the key set is 1/4" too high, counter sink the holes 1/4".
Cut off the plastic key set post using a hacksaw. Example: If the key set is 1/4" too
high, cut 1/4" off the post.
Note: If the key set is too low, use shims or washers to raise the key set.
I
N S T A L L I N G
T
H E
K
E Y S E T
M
O U N T I N G
T
H E
C
I R C U I T
B
O A R D
Step 8
The necessary circuit boards, amplifier and transformer are mounted onto one wooden
board. Install this to the keybed behind the key set using four (4), 1-1/2" screw.
M
O U N T I N G
T
H E
S
P E A K E R S
Step 9
The two speaker boxes each contain one midrange and one woofer. These can be
mounted anywhere above or below the keybed or on the back of the piano
P
E D A L
C
O N T A C T S
Step 10
Extend the cord out of the jack panel, down to the pedals. Using the original pedals,
mount the pedal contacts under the soft and sustain pedals only, using the yellow contact
for the sustain pedal and the green contact for the soft pedal. Adjust contacts up or
down for sensitivity.