INSTALLATION: PREPARING PANEL FOR ENROLLMENT
1.
Create Alarm.com Customer Account
- Select service plan (see Service Plan Requirements) and register the
Alarm.com module serial number on the Alarm.com Dealer Website.
2.
Install Image Sensor Daughterboard if necessary
. – First check Hardware Compatibility to verify if module
needs a daughterboard. If it does, see Daughterboard Install Guide for daughterboard installation instructions.
3.
Install Alarm.com Module inside Control Panel
4.
Register Module and Test
- Power up the panel and initiate a comm-test to ensure the Alarm.com module is
properly installed and communicating with the Alarm.com NOC.
5.
Enroll Sensor in Panel
– Instructions specific by panel
INSTALLATION: ENROLLING IMAGE SENSOR TO PANEL
Qolsys IQ Panel / DSCTouch
Install Process:
Enroll Sensor in Panel - To enroll the sensor on an IQ Panel, follow these steps at the control panel:
1. Put the panel into add mode. On the panel, select the “Settings” icon at the bottom left hand corner of the
homepage > Enter the installer code (1-1-1-1 by default) > Select the “Installation” > Select the “Security Sensors”
> Select the “Auto Learn Sensor”.
2. Once on the Auto Learn page, insert the batteries into the Image Sensor. The Image Sensor will progress from
blinking red to solid red to blinking yellow. This indicates that the Image Sensor is in learn mode.
3. Wait approximately 20 seconds for the Image Sensor to enroll to the panel. The screen on the control panel will
display the following: “Image Sensor [X] is requesting to be added in your list. Do you want to continue? ” > Click
OK. The LED on the Image Sensor will turn solid yellow indicating that it has successfully found the panel.
4. On the panel screen, select the sensor type, sensor name, chime type, sensor group and voice prompt settings.
Make sure the Image Sensor name is unique to that Image Sensor. The Image Sensor will NOT enroll successfully
if the new Image Sensor has the same name as an Image Sensor that is already enrolled on the panel. Select
“Add New”.
5. Exit “Auto-Learn” mode on the panel. The Image Sensor LED will alternate between green and yellow while the
customer’s device list is updated with Alarm.com. The LED will turn solid green when the Image Sensor has been
successfully added to the customer’s account. Note: If you move (tamper) the Image Sensor after the LED has
turned solid green, the Image Sensor will enter test mode for 3 minutes indicated by red LED when motion is
detected. You may continue with the mounting portion of the installation when in test mode. See the Image Sensor
LED Reference Chart for more details.
The sensor is now learned into the panel. Sensors are enrolled in group 17 by default. To change the sensor group after
the sensor is enrolled, use the Edit Sensor icon under Settings > Installation > Security Sensors. Image Sensors may be
enrolled in groups 15, 17, 20, 25 or 35. After enrollment, be sure to keep the sensor and panel powered so the sensor
can complete an initialization process with the Alarm.com Network Operations Center. This process will take several
minutes. Images cannot be captured until initialization is complete.
Qolsys IQ Panel 2
Install process:
https://answers.alarm.com/Installation_and_Troubleshooting/Image_Sensor/Qolsys_IQ_Panel_2_Image_Sensor/Qolsys_IQ_Panel_2_Image_Sensor_Installation_Guide_-_ADC-IS-300-LP
Updated: Tue, 17 Apr 2018 13:46:50 GMT
7
