QNO FQR7200, Руководство пользователя

Страница: 55 / 184

Multi-WAN Router
52
input “0” in the IP boxes.
Destination IP: In the boxes, input an external static IP address. For example, if
connections to destination IP address 210.11.1.1 are to be restricted to
WAN1, the external static IP address 210.1.1.1 ~ 210.1.1.1 should be
input. If a range of destinations is to be assigned, input the range such
as 210.11.1.1 ~ 210.11.255.254. This means the Class B Network
Segment of 210.11.x.x will be restricted to a specific WAN. If only
specific Service Ports need to be designated, while a specific IP
destination assignment is not required, input “0” into the IP boxes.
Interface: Select the WAN for which users want to set up the binding rule.
Enable:
To activate the rule.
Add To List: To add this rule to the list.
Delete selected
application:
To remove the rules selected from the Service List.
Moving Up &
Down:
The priority for rule execution depends on the rule order in the list. A rule
located at the top will be executed prior to those located below it. Users
can arrange the order according to their priorities.
Note
！
The rules configured in Protocol Binding will be executed by the device according to their priorities
too. The higher up on the list, the higher the priority of execution.
Show Table:
Click the “Show Table” button. A dialogue box as shown in the following figure will be displayed. Users
can choose to sort the list by priorities or by interface. Click “Refresh” and the page will be refreshed; click
“Close” and the dialogue box will be closed.