4.
r
Thread the Shock Cord through the Main Nose
Cone Molded Hook and tie a knot around the Molded
Hook. Place a drop or two of CA on knot to secure the
Shock Cord to the Molded Hook.
19
5.
r
Group the Parachute Shroud Lines together
forming a set of loops at one end. Ensure the Shroud
Lines are not tangled. Unclasp the Snap Swivel and
attach the Parachute loops to the Snap Swivel. Re-
clasp the Snap Swivel to secure the Parachute.
6.
r
Finish final assembly by lightly wrapping the
Shroud Lines around the Parachute. Pack the
Parachute, Heat Shield, and Shock Cord into parachute
compartment of the Main Body Tube. Push the Main
Nose Cone onto the Main Body Tube. Place completed
XP-RAPTOR on flat surface and step back.
TAKE A BOW OR TWO FOR SUCCESSFULLY COMPLETING ALL THE STEPS !
1.
r
Locate the Shock Cord Bumper and drill a
Shock Cord hole through the center. Pull the Shock
Cord tautly out of the Main Body tube and thread it
through the created hole of the bumper. Push the
bumper down the Shock Cord until it is located
approximately 1/4” from the forward end of the Upper
Main Body Tube when the cord is taught. Use CA to
glue the bumper permanently to the Shock Cord.
3.
r
Thread the Shock Cord through the Snap
Swivel as shown and secure it with a knot past the Heat
Shield two-thirds of the way up the Shock Cord from the
Main Body tube. Apply a drop or two of CA on the knot
after pulling it tight.
Final Assembly (10-15 mins)
Unclasp
Clasp
C
A
G
LU
E
Thread cord
and form a knot
Pull knot
tight apply CA
Thread Shock Cord
through Bumper
Glue in place
Drill Shock
Cord hole
C
A
G
LU
E
Attach Parachute onto
Snap Swivel
2.
r
Pull the Shock Cord tautly out of the Main Body
tube and thread it through the corner attachment hole
located on the Heat Shield.
Thread Shock Cord
through Heat Shield
Tie Shock Cord
onto Eye Hook
Apply CA to
secure knot
C
A
G
LU
E
Attach Snap Swivel beyond Heat Shield
and 2/3 up Shock Cord
2/3
1/3
