Qlogic StorageWorks MPX200, Руководство пользователя

Страница: 37 / 240

2–Command Reference
Command Syntax
ISR654601-00 D 2-13
FC Port (1=FC1 2=FC2) [ ] 1
GE Port (1=GE1 2=GE2) [ ] 1
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ] 172.35.15.11
Subnet Mask [0.0.0.0 ] 255.255.254.0
Gateway IP Address [0.0.0.0 ] 172.35.14.1
Remote IP Address [0.0.0.0 ] 172.17.136.18
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Enabled ]
Window Scaling Factor (Min=0, Max=9) [7 ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto ]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]
VLAN (0=Enable, 1=Disable) [Disabled ]
FCIP SW Compression(0=Enable,1=Disable,2=Auto)[Auto ]
All attribute values for FCIP Route 1 will now be saved.
The following shows an example of the
fciproute add
command used to add
a 10Gb FCIP route. At the
GE Port
prompt, you must select a 10Gb Ethernet
port. Set the
Window Scaling Factor
to 3 for the default window size. Set
the
Bandwidth
, Mbit/sec
in a range from 1Mbps to 10000 Mbps.
iSR6200 <1> (admin) #> fciproute add
A list of attributes with formatting and current values will follow. Enter a
new value or simply press the ENTER key to accept the current value. If you
wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
FC Port (1=FC1 2=FC2) [ ] 1
GE Port (1=GE1 2=GE2 3=10GE1 4=10GE2) [ ] 3
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ] 172.35.15.11
Subnet Mask [0.0.0.0 ] 255.255.254.0
Gateway IP Address [0.0.0.0 ] 172.35.14.1
Remote IP Address [0.0.0.0 ] 172.17.136.18
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Enabled ]