Qlogic StorageWorks MPX200, Руководство пользователя

Страница: 159 / 240

A–Simple Network Management Protocol
SNMP Trap Configuration
ISR654601-00 D A-3
SNMP Trap Configuration
SNMP trap configuration lets you set up to eight trap destinations. Choose from
Trap 1 through Trap 8 to configure each trap.
Table A-2 describes the parameters
for configuring an SNMP trap.
Table A-2. SNMP Trap Configuration Parameters
Parameter Description
Trap n
enabled
Enables or disables trap n . If disabled, the trap is not configured.
Trap address
*
Specifies the IP address to which the SNMP traps are sent. A maximum of eight
trap addresses are supported. The default address for traps is
0.0.0.0
.
Trap port*
Port number on which the trap is sent. The default is
162
. If the trap destination
is not enabled, this value is 0 (zero). Most SNMP managers and management
software listen on this port for SNMP traps.
Trap version
Specifies the SNMP version (
1
or
2
) with which to format traps.
Table Note
* Trap address (other than 0.0.0.0 .) and trap port combinations must be unique. For example, if trap 1 and trap 2
have the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the same port value,
they must have different addresses.