When using starting motor to start the engine, disassemble
the high-voltage wires and earth them so as to avoid the
generation of spark.
4. Lubricate all control cables.
5. Use proper support to prop up the front and rear wheel.
Then make sure that the motorcycle is in a steady position.
6.Seal the opening of the muffler with plastic bag to
prevent water from entering in.
Do all care and maintenance work properly prior to storing
the motorcycle.
SPECIFICATIONS
Model
AC150
Overall length
Overall width
Overall height
Distance between axles
Min. ground clearance
Max. vehicle speed
Min. fuel consumption
Min. turning diameter
72.61in
26.22in
44.17in
50.79in
51.12in
85km/h
≤
2.8L/100km
141.73in
motorcycle.
1. Drain the oil stored in gasoline tank, fuel tube and
carburetor.
2. Take off the empty fuel tank and pour in a cup of
SAE10W30 or SAE20W40 engine oil. Shake from
left to right, and right to left to spread a layer of oil
inside the fuel tank.Then pour out the engine oil from
the fuel tank and reinstall the fuel tank.
3. Remove the spark plug,and pour a spoonful of SAE
10W30 or SAE 20W40 engine oil into the cylinder.
Install the spark plug,tread the engine starting lever
for several times (connect the high voltage wire of the
spark-plug) and allow the engine lubricating oil to be
uniformly distributed on the cylinder wall .
Warning
7. Apply a coat of antirust oil on all metal surfaces if
it is stored in a place with high moisture and salt content.
But be careful not to allow the rubber parts or seat of
the motorcycle to touch the oil.
8. Take out the battery for charging, and store it in a dry
place. Charge it at least once every month, and do not
store it in hot (higher than 86 F ) or cold (lower than
32 F ) place.
Warning
USER'S MANUAL
29
