Qleen DISY E, Информация пользователя

Страница: 19 / 36

| 19
Cleaning
5 Cleaning
Caution Risk of injury
• Tripping hazard: Pay attention to the hose when working!
• Crash hazard: Place the poles on the floor during work interruptions! Do not lean against
vertical walls, this may cause them to fall over and result in injury or damage to the
equipment!
• Crash hazard: Do not work with the pole system above wind force 2 (>3,3 m/s)
• Risk of electric shock: Do not work with the pole system under high-voltage lines!
For most soiling, the PUREWATER is completely sufficient.
Only heavily soiled and oily or greasy surfaces must be pre-treated with a cleaning solution.
Dirt that can only be removed by intensive mechanical cleaning (e.g. glass plane) should also be pre-treated
accordingly.
The higher the level at which work is carried out, the greater the dirt load at the lower levels, because the
"foreign dirt" from the higher level is added to the "inherent dirt".
This should be taken into account when calculating the work and the order.
1. Mount the pole system to the maximum height of the cleaning area,
see Page 16 (4.11 Mounting the rods and brush)
2. Position the brush in the upper area and activate the desired cleaning mode with the remote control
3. Move the brush from one side to the other with even up and down movements over the surface to be
cleaned
4. To increase the mechanical cleaning power, press the pole system lightly against the surface to be
cleaned with the help of the guide hand
5. Proceed in the same way for the surfaces below until the entire surface has been cleaned
6. Adjust the pole system according to the working height to ensure fatigue-free work