—
26
—
1. Remove two screws and take
off the lamp lens
2. Press the bulb and turn it
leftward to take it out.
3.
To install a new bulb, press it
down and turn it rightward.
Precaution:
After installing the lamp lens, be
careful not to over tighten the
screws to avoid damaging the
lamp lens.
Tail/Brake Lamp
1. Remove the lamp cover by
loosening the two screws.
2. Screw out the bulb by pressing
and turning it to the left.
3. Renew a bulb.
Air Filter
If dust clogs the air filter
element, intake resistance increases
as the output power decreases. The
increase of gasoline content in the
mixing gas leads to the increasing of
fuel consumption. To avoid this,
check and clean the air filter element
as the following steps after riding for
every 3,000 km.
1. Remove the right chassis cover
with the key.
2. Loosen the fixing screws and
remove the air filter cover.
3. Withdraw the bright plastic flake
and outer frame.
4. Separate the foam plastic from
the outer frame.
Carburetor
The stability of carburetor
contributes to the performance of the
engine. The carburetor has been
adjusted to the best state before
leaving the factory. Please do not
attempt to make unnecessary
adjustment. The carburetor has two
adjustment items that are throttle
cable clearance and idle speed. The
new motorcycle should be adjusted
according to the following method
after running for 1,000 km or every
3,000 km.
Adjustment of the
Carburetor’s Idle Speed (rpm)
