Qimova chair | User manual
Version 1.11 | Page 37 af 43
Occupant restraint guides (strap
guides)
The belt restraints (1) should be
attached through the ‘Strap Guides’ (2)
placed in the pivot points of the
backrest.
The ‘Strap Guides’ will by them selves
align (rotate) to the most suitable
position.
Figure 25.
Figure 25
Belt restraints should be adjusted as tightly as possible, but still remain comfortable for the
user.
Belt restraints should not be twisted when in use.
Care should be taken when applying the occupant restraint to position the seatbelt buckle
so that the release button will not come into contact with wheelchair components in the
case of a crash.
9.2
Vehicle clamping system
Transport fittings and clamps are installed on the bottom frame to achieve safe automobile
transportation. The fittings are mounted with one on each side of the bottom frame and
the clamps are mounted in front of the bearing tube.
If necessary these can be used for lifting the wheelchair.
Rear restraints, rear view
The angle of the rear restraints should be
80° or higher.
The distance between the rear restraints
should be 30 cm or more.
Qimova recommends that the angle is as
close as possible to 90°.
Figure 26.
Figure 26
