User manual | Qimova chair
Page 14 of
43
| Version 1.11
Figure 3
Enable and disable use of remotes
Hold magnet-side at remote top end up against the C3-controller (4) directly where the
little round indentation in the plastic is, just next to the battery (2) as shown in Figure 3.
Enable use of a remote
Start-up controller and hold remote (1) close to C3 (4) as shown on the Figure 3. Press on a
random button for about 3 seconds to enable a remote (1) for use. C3-controller (4) returns
with 1 short sound.
Disable use of all remotes
Place remote (1) as shown on the Figure 3, press on a random button for about 15 seconds
(after 3 seconds a short sound is emitted but continue to push the button). The C3-
controller returns with 2 short sounds. Use of the remote again requires that you proceed
with a new enable remote procedure.
It is possible to store up to a maximum of 10 different remotes in a C3-controller. When
enabling the 10th remote, the C3-controller will emit 1 long sound.
C3-controller alarm types
1)
The battery needs to be charged if the C3-controller gives 5 short sounds immediately
after the buzzer sound is finished when a battery is connected to the C3-controller. It is not
possible to run actuators.
2)
If the battery voltage level goes below the minimum allowed value while running, the
C3-controller emits 3 short sounds. Then it is only possible to run the actuators in a
customer predefined backwards direction, before the battery needs to be removed for
charging.
3)
If the battery reaches the absolute minimum allowed voltage level during run, the C3-
controller emits only 1 short sound, all actuators stops momentarily and the C3-controller
disconnects itself to save power and protect the battery from permanent damage. The
