Qilive Q.6598, Инструкция по эксплуатации

Страница: 23 / 178

23
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time otherwise, the detergent
may have already been released and the appliance may have already drained the wash water. If this
is the case, the appliance needs to be reset and the detergent dispenser must be refilled:
■ Open the door a little to stop the appliance. After the spray arm stops working, open the door
completely.
■ Press the P button for more than 3 seconds. The appliance will be in stand-by state.
■ You can change the program to the desired cycle setting.
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case,
follow the instructions below:
■ Open the door a little to stop the washing.
■ After the spray arms stop working, you can open the door completely.
■ Add the forgotten dishes.
■ Close the door.
■ The appliance starts running again.
WARNING!
It is dangerous to open the door mid-
cycle, as hot steam may scald you.
Notes:
■ If overflow occurs, turn off the main water supply before calling service.
■ If there is water in the base pan because of an overfill or small leak, the water
should be removed before restarting the appliance.
6.8. Removing the dishes
To prevent water dripping from the upper basket into the lower basket, empty the lower basket first,
followed by the upper basket.
WARNING!
Items will be hot! To prevent damage,
do not take glass and cutlery out of the appliance for
around 15 minutes after the program has ended.
Note: To save energy, in stand by mode, the appliance switches off automatically if there
is no operation for 30 minutes.