Qilive Q.6594, Руководство пользователя

Страница: 19 / 260

19
EN
4. BEFORE FIRST USE
1. Unpack all parts.
2. Check for completeness and shipping damage immediately after unpacking. If
your shipment is damaged or incomplete, please contact our customer service.
5. INSTALLATION
WARNING! Electrical shock hazard. Disconnect electrical power before
installing the appliance. Failure to do so could result in death or electrical
shock.
ATTENTION! The installation of the pipes and electrical equipment should be
done by professionals.
5.1. POWER CONNECTION
Look at the rating label to know the rating voltage and connect the appliance to the
appropriate power supply. Use the required fuse 10 A / 13 A / 16 A, time delay fuse or
circuit breaker recommended and provide separate circuit serving only this appliance.
5.2. WATER SUPPLY AND DRAIN
Cold water connection
( Fig. C : 1 = Ordinary supply hose / 2 = Safety supply hose)
■ Connect the cold water supply hose to a threaded ¾” connector and make sure
that it is fastened tightly in place.
■ If the water pipes are new or have not been used for an extended period of time,
let the water run to make sure that the water is clear. This precaution is needed to
avoid the risk of the water inlet to be blocked and damage the appliance.
■ Safety supply hose: The safety supply hose consists of double walls. The hose’s
system guarantees its intervention by blocking the flow of water in case of the
supply hose breaking and when the air space between the supply hose itself and
the outer corrugated hose is full of water.
WARNING! A hose that attaches to a sink spray can burst if it is installed on
the same water line as the appliance. If your sink has one, it is recommended
that the hose be disconnected and the hole plugged.
How to connect the safety supply hose
■ Pull the safety supply hoses completely out from storage compartment located at
rear of the appliance.
■ Tighter the screws of the safety supply hose to the faucet with thread ¾”.
■ Turn water fully on before starting the appliance.
How to disconnect the safety supply hose
■ Turn off the water.
■ Unscrew the safety supply hose from the faucet.
5.3. CONNECTION OF DRAIN HOSES
( Fig. D ).
■ Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it
run into the sink, making sure to avoid bending or crimping it. The height of drain
pipe must be less than 1000 mm. The free end of the hose must not be immersed
in water to avoid the back flow of it.