QGarden 1938288001, Инструкция по эксплуатации

Страница: 14 / 24

CHANGING MOWER BLADES
WARNING
Never carry out any assembly operations or adjustments with the power connected to the
mower. Always ensure that the power button is in the off position and that the power plug is
disconnected from the supply.
1.
Periodically check the blades (11) for damage and balance.
2. If there are broken ends or other damage or the two blades are out of balance, they
must both be replaced.
3. With the safety button (3) in the off position and the power plug removed from the
supply, turn the mower on its back as shown in figure E.
4. Unclip the old blades (11) from the pins (12) and replace them with new ones.
5. Return the mower to the upright position.
6. Reconnect the power cable to the supply and run the mower for a few minutes to check
that the blades are properly fitted and that there is no undue noise or vibration.
7. Use only blades as recommended by the manufacturer.
ADJUSTING CUTTING HEIGHT (20-30-40mm)
1. Use the blade wrench (9) to remove the blade bolt (9a).
2. Remove the blade holder disc (10) remove the blades (11) from their anchor pins (12)
3. Choose your chosen height. This may require the blade holder disc to be flipped over.
4. Replace the blades on the anchor pins on the blade holder disc (10) and tighten the
blade bolt (9a).
WARNING
Do not set the cutting height too low, especially at the beginning of the mowing season.
Cutting the grass too low will discourage its growth and allow weed proliferation. You will
achieve a far better lawn by cutting it less short and mowing more often.