Speedkid2 2018
Subject to change. 12|2017 –
13
f
Hold the end of the stabilizer bar to the rear roof rack
so that the pipe clamp contacts near the upper pipe
bend.
f
Apply light pressure to push the tube clamp onto the
tube of the rear roof support. The connection has been
made properly when the tube clamp engages audibly
and sits securely on the tube.
f
Lift the second clamp of the stabilizer bar so far that
you can fasten it in the same way on top of the tube of
the front roof rack.
f
Repeat the procedure to mount the second stabiliser
rod on the other side of the cabin.
Caution!
Release the front tube clamps of the stabiliser rods before you fold up the cabin. When
doing this, pay attention to the instructions in the chapter
„Storage“ on page 28
.
Inserting the wheels
f
Lift the cabin a little bit in order to install the wheel easier.
f
Insert one wheel into the cabin’s axle retainer:
–
Hold the wheel so that you can press your thumb
onto the rubber cap on the outside of the wheel
hub.
–
Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will go
into the axle retainer.
–
Release the rubber cap to secure the push-in axle.
f
Pull on the wheel to check that the wheel is locked in the axle retainer.
f
Insert the second wheel in the same way.
Danger!
After mounting the wheels, secure the
Speedkid2
whenever you park it so as to prevent
it from rolling away, see
„Applying the parking brake“ on page 19
.
f
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 4 bar).
If necessary, use an air pump for car valves to top up with air.
Assembly