Speedkid 2020
Subject to change without notice. – 07|2020 –
13
Inserting the wheels
»
Remove the black rubber caps from the ends of the thru-axles and then dispose of them.
»
Lift the cabin a little bit in order to install the wheel easier.
»
Insert one wheel into the cabin’s axle retainer:
–
Hold the wheel so that you can press your
thumb onto the rubber cap on the outside of
the wheel hub.
–
Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will
go into the axle retainer.
–
Release the rubber cap to secure the push-in
axle.
»
Pull on the wheel to check that the wheel is locked
in the axle retainer.
»
Insert the second wheel in the same way.
Assembly
Danger!
After mounting the wheels, secure the Speedkid whenever you park it so as to
prevent it from rolling away, see
„Applying the hand parking brake“ on page 19
.
»
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 3 bar).
If necessary, use an air pump for car valves to top up with air.
Installing the wheel guard
The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars or
similar obstacles.
»
Make sure that the slide covers for the wheel guard
are fixed and tightened on both sides.
»
Slide the wheel guard onto the slide holder as
shown in the picture.
»
Be sure that the fixing mechanism locks audibly.
»
Repeat the procedure on the other side of the
trailer.
