KidGoo2 – Q9000-S
Subject to change. – 05|2016 –
15
Assembly
f
Tilt back the cabin and place it on its reverse side. This makes the lower cabin frame accessible
for assembly.
Securing the wheel axle
The wheel axle is equipped with a disc brake system and adjustable leaf suspensions. The
suspension effect of the two red leaf suspension plates can be adjusted by moving a clamp, see
“Adjusting the suspension” on page 33
.
Screw the wheel axle with leaf suspensions into the wedge-shaped leaf suspension mount of the
cabin frame. You will need 4 hexagon socket screws (M7) as well as the 8 appropriate washers
and 4 spring lock washers from the screw set.
f
Place 2 washers and 1 spring lock washer on each
screw. The spring lock washer must be placed
between the two washers.
f
Adjust the leaf suspension plates using the clamps so
that their holes are placed on top of each other.
f
The knurled screws of the clamps point downwards
(away from the cabin) when assembling the axle.
f
Hold the wheel axle with the leaf suspensions against
the wedge-shaped leaf suspension mount.
f
Screw the four screws prepared with washers and
spring lock washers through the leaf suspension into
the leaf suspension mount.
f
Tighten the screws using a hex key (tightening torque
max. 4 – 5 Nm).
Covering leaf suspensions
The leaf suspensions are equipped with a cover to protect against contusion. An imprinted scale
aids the adjustment of the suspension effect.
The cover is screwed to the cabin frame using 3 screws each. You will need the 6 Phillips screws
from the screw set.
f
Hold the cover against the cabin frame so that the
imprinted scale labels the adjustment track of the leaf
suspension clamp.
f
Mount the cover to the cabin frame using three
screws.
f
Ensure that the screws are only tightened enough
using a Phillips screwdriver, so that the cover does not
get damaged.
f
Mount the second cover in the same way.
