1B - Screw into Stud Behind Drywall
Locate the studs by using a stud finder. Carefully mark the
center locations of the studs at the top of the furniture.
Pull the furniture out from the wall and measure 18”
(45 cm) down and mark the location for the Wall Brackets.
Test one more time with studfinder to secure. Next peel
the protective liner from the adhesive* and position the
Wall Bracket in the desired location with the strap
pointing upwards.
Using the included screws attach the Wall Brackets
through the two screw holes in the center. Once screwed
in attach the Covers over the Wall Bracket.
*IMPORTANT: The adhesive is only a help to hold the Wall
Bracket during installation. The Wall Bracket MUST be at-
tached with the SecureHooks™ or screws for safety!
Step 2 - Attaching to the Furniture
There are two options to attach the 2 in 1 Anti-Tip TV
Straps to the furniture. (3A) On top of the furniture with
the Zero-Screw Adhesive Furniture Plate or (3B) Screw
the Cam Lock into the back of your furniture.
2A - Adhesive Furniture Plate
Push the furniture back towards the wall.
Line up the Furniture Plate so it is directly above the Wall
Bracket. Remove protective Liner and while holding the
Cam Lock against the back of the furniture, fold the Fur-
niture Plate down until it sticks. Press on it for 30 seconds
for good adhesion. Do the same for the second strap on
the other side.
Note: The adhesive needs to set for 24
hours for maximum adhesion.
2B - Screws
Push the furniture back towards the wall.
Line up the Furniture Plate so it is directly above the Wall
Bracket. When attaching with screws to the back of the
furniture, the Furniture Plate can be removed by unscrew-
ing the hinge pin and pulling it out. Mark the hole loca-
tions and drill pilot holes using a 3/32” drill bit. Be careful
not to damage the top of your furniture. Attach the Cam
Lock with included screws.
2A
2B
1B
