Step 1 - Positioning and attaching the Wall Brackets
The Furniture Anti-Tip Kit should be placed within 2-15”
(5-35 cm) of each end of the furniture. There are two
options how to attach the Wall Brackets. (1A) The Ze-
ro-Screw option into a hollow drywall using the Secure-
Hooks™ or (1B) with screws into the studs behind the
drywall (For plaster walls use this option). For installation
into any other wall material, use only the appropriate
hardware for that material. Consult a handyman or hard-
ware store for advice.
Insert the point of
one of the Secure-
Hooks™ in the upper
right hole in the Wall
Bracket. While turn-
ing the Hook from
side to side simply
push it in until it pen-
etrates the drywall. Continue to feed the Hook all the way
in and then turn the handle around until it locks under the
Catch. Put a second Hook in the lower left hole in the Wall
Bracket, but this Hook will turn in the opposite direction
and then lock under the Catch.
Repeat for second Wall Bracket and then attach the Covers
over the Wall Brackets to secure the Hooks.
*IMPORTANT: The adhesive is only a help to hold the Wall
Bracket during installation. The Wall Bracket MUST be at-
tached with the SecureHooks™ or screws for safety!
2A -Insert SecureHooks™ into hollow drywall
Find the center locations in between two studs toward the
ends of the furniture. Use a stud finder to locate the studs.
Carefully mark the center locations in between the studs
at the height of the furniture.
Pull the furniture out from the wall and measure 18” (45
cm) down and mark the location for the Wall Brackets.
Next peel the protective liner from the adhesive* and posi-
tion the Wall Bracket in the desired location with the strap
pointing upwards.
SecureHook™
on catch
1A
