QDI SynactiX 1E, Руководство пользователя

Страница: 50 / 65

Manual for Synactix 1E
BIOS Description
l IDE HDD Block
Enabled
Allows IDE HDD to read/write several sectors at
Mode once.
Disabled
IDE HDD only reads/writes a sector once.
l KBC input clock 6 MHz Sets the PS/2 Keyboard input clock as 6/8/12
8 MHz
/16MHz.
12 MHz
16 MHz
l Power On BUTTON Uses the power button to power up the system.
Function
ONLY
Password
Enables the Keyboard Password Power-On.
l KB Power ON
Enter
Uses the keyboard password to power up the
Password system.
l Onboard FDC
Enabled
Onboard floppy disk controller is enabled.
Controller Disabled Onboard floppy disk controller is disabled.
l Onboard
3F8/IRQ4,
Defines the onboard serial port address and
Serial Port 1/2 2F8/IRQ3, required interrupt number.
3E8/IRQ4,
2E8/IRQ3,
Auto
Onboard serial port address and IRQ are
automatically assigned.
Disabled
Onboard serial port is disabled.
l UART Mode Normal This option is used to configure UART Mode.
Select
l RxD, TxD Active Hi, Lo The default setting is recommended.
Lo, Hi
Lo, Lo
Hi, Hi
l IR Transmission Enabled The default setting is recommended.
Delay
Disabled
l UR2 Duplex Mode Half The default setting is recommended.
Full
l Use IR Pins IR-Rx2Tx2
RxD2, TxD2
l Onboard Parallel 378/IRQ7, Defines onboard parallel port address and IRQ
Port
278/IRQ5,
channel.
3BC/IRQ7
Disabled
Onboard parallel port is disabled.
l Parallel Port SPP Defines the parallel port mode as standard
Mode
EPP
Parallel Port(SPP), Enhanced Parallel Port(EPP), or
ECP Extended Capabilities Port(ECP).
ECP+EPP
l EPP Mode Select EPP1.7 The default setting is recommended.
EPP1.9
l ECP Mode Use 3 The default setting is recommended.
DMA
1